Controlador de Nível de Água Automático Controlador de Bomba Cisterna Interruptor de Líquido Automático com Sensores Df-96a Df-96d Df-96dk

Note:

According to product options !!!
We send products according to the product options you selected.

Send from China, only English type

Send from Russia, two type random send

This meter beside black button is for Manual or automatic conversion

This product uses the integrated circuit, combined with the high-rise buildings, the sink (water tower) is designed to enhance the level classification has joint control under the sink, sink drainage and water protection and other functions, can automatically tank water, drainage, and effective pool water level to prevent water overflow or pump idling high damage, is an industrial, household products are applicable. Very suitable for urban, rural, school, where mining enterprises and domestic water wells – Well Water Project, is widely used in printing and dyeing, chemical, food, beverage, wine, sugar and other industries.

Function and purpose

1. Instrumentos de Medição de Fluxo

Single-control UP pool (water storage) installation instructions shown in figure 1

2. Sensores de Fluxo

A(red)—Upper water level control point. When water level gets to A point,

the probe touch water and controller can stop the pump by auto.

B(blue)—Lower water level control point. When water level gets off B point,

the probe out of reach water and controller can start the pump by auto.

C(black)—Should be placed in bottom of pool as the common line.

D(green) and E(yellow)are connected with C (black).

Single-control DOWN pool(drain water)installation instructions shown in figure 2.

3. de Bomba Cisterna Interruptor de Líquido Automático

E—Upper water level control point. When water level gets to E point,

the probe touch water and controller can start the pump by auto.

D—Lower water level control point. As liquid level gets off D point,

the probe out of reach water and controller can stop the pump by auto.

C—Should be placed in bottom of pool as the common line.

A&B—disconnected

1 . Lack of water protection installation instructions shown in figure 3.

4. Instrumentos Analíticos e de Medição

C&D—Lower water level control points. When water level gets off this point,

C or D probe out of reach water and controller can stop the pump by auto.

E&C—short-connected;

A&B—disconnected

2 . Joint control UP and DOWN pool installation instructions shown in figure 4.

5. Contrôleur de Niveau Contrôleur de Pompe et de Interrupteur de Liquide Automatique Avec Sondes

A—Upper water level control point in UP pool. When water level gets to A point,the probe touch water and controller can stop the pump by auto.

B—Lower water level control point in UP pool. When water level gets off A point, the probe out of reach water and controller can start the pump by auto.

C—Should be placed in bottom of UP and DOWN pools as the common line.

D—Lower water level control point in DOWN pool. When water level gets off D point, the probe out of reach and controller can stop the pump by auto.

E—Upper water level control point in DOWN pool. When water level gets to E point, the probe reach water and controller can start the pump by auto. Then pool starts to drain water. If not, E point disconnected

Used to solve problem:

1. On power but no work:

a. Check the red indicator is on or not. If not, make the connection is good enough;

2. When water level is above or below probes but the pump does not start or stop by auto, Please check it like the following.

a. Whether the probe is placed too high or low so that water level can reach or out of reach it;

b. The connection of upper &lower line or probe is dislocation by error or short connected;

c. To check the probe whether it is rust or not or the connection is good enough.

d. C- Check the common line whether it is placed in the lowermost bottom of pool.